Floor notes

First Article

A short workshop note on first-off inspection for teams who need the first machined part right before the batch runs.

The first finished piece tells you whether the drawing, setup, tooling, and machine condition are all speaking the same language.

First-off inspection only works when the setup details are written down while the machine is still warm. For a turned shaft, milled plate, or bored housing, note the datum used, the measuring tools on hand, and the actual size recorded from the first acceptable part.

First-off checks before batch release

  • Machine and job number recorded
  • First part measured and marked
  • Drawing revision and tolerance called up clearly
  • Inspector, operator, and site listed

A first article note should sit next to the job card, drawing, and measurement record. That way the next setter can see which tool offsets changed, which diameter was critical, and where the first part nearly went out of tolerance. On older workshop machines, those notes are often more useful than memory alone.

Where first article saves scrap

First Article is about getting the first machined part checked properly before the rest of the batch runs. For workshops under pressure, that early inspection can prevent wasted material, repeat setup changes and the wrong dimension being copied across the job.

On a South African workshop job, the first machined piece is where mistakes usually show themselves. A chuck jaw can seat unevenly, a vice stop can shift, or a worn ballscrew can leave size wandering between passes. In Randburg, Johannesburg, Durban, and Cape Town, that first check often decides whether material gets preserved or wasted.

Inspection should cover more than one finished dimension. Check surface finish, burrs on edges, hole position, thread fit, and whether the part sits correctly against the intended datum. When coolant concentration is off or inserts are near the end of life, the first component often shows it before the rest of the batch follows the same error.

What the first part must show

The first approved component should prove that the drawing, fixture, tools, offsets, and measuring method agree with one another. It must also show whether the machine can hold size once the spindle and slides have come up to operating temperature. One signed first-off record is better than a pile of mixed readings taken after scrap has started.

Before any pallet, crate, or loose part leaves the workshop, match the label and paperwork to the inspected item and machine reference. Keep the first article note with the delivery record so there is no confusion later over revision level or accepted dimensions.

  • Recorded sizes before production continues
  • Critical dimensions checked against drawing
  • Signed inspection note with the job

Workshop conditions that affect first-offs

Many South African shops run mixed-age equipment, repaired fixtures, and substitute tooling when supply chains get tight. That makes first article inspection more important, not less, because the machine may no longer behave exactly as the original setup sheet suggests. If a spindle repair, control change, or replacement slide nut has been done, record it against the job early.

Coastal humidity can affect bare stock, measuring equipment, and storage between operations. Inland dust gets into way covers, cabinets, and coolant systems, which can show up as inconsistent finish or drag during a proving cut. Power cuts and restarts also matter, because interrupted warm-up and repeated homing can alter confidence in the first reading.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Notes to capture on the first part

A short workshop note on first-off inspection for teams who need the first machined part right before the batch runs.

Write the first article result on the day the part is checked. Include the instrument used, the dimension found, any offset correction made, and who accepted the piece for production. That record helps when the foreman, buyer, or quality file needs proof of how the run was released.