Floor notes

Power Windows

A short workshop note on power windows when workshop outages interrupt testing, fitting, and machine restart checks.

Electrical faults are often traced back to the same oversights. On South African workshop floors, teams may not record voltage variation, panel condition, or the exact point where a machine drops out. Power Windows looks at power quality checks before replacing machine-tool parts that may not be at fault.

Record the incoming voltage, the time of the drop, and which control or drive stopped first before assumptions are made about failed components.

Checks after a supply dip

  • Incoming voltage and trip time noted
  • Photo of panel, meter, or alarm screen
  • Control model and alarm code written down
  • Workshop, contact, and machine location listed

Read this note alongside the parts and service pages for the machine involved. Power quality faults can look like bad relays, drives, contactors, or control boards when the root cause sits in the incoming supply. A written record helps the next inspection start from measurements rather than memory.

Outage checks on restart

Power Windows deals with the checks to make when workshop outages interrupt testing, fitting or restart work. If supply drops during a job, machines, controls and partly completed inspections all need to be reviewed before the floor carries on.

Begin with what happened just before the machine stopped. Note whether the spindle was under load, whether coolant pumps were running, and whether the control went dark or stayed live with an alarm. In Randburg, Johannesburg, Durban, and Cape Town, unstable supply, dust in panels, and damp coastal conditions can all change the result of the same test.

Take the first photos at the cabinet and the machine HMI before anything is reset. Capture breaker positions, overload relays, VFD displays, and any burnt smell or discolouration around terminals. Those details matter when a machine restarts later and the original evidence has vanished.

What the note leaves you

You should leave with a sequence of checks for safe restart and fault tracing. That usually includes supply readings, panel observations, alarm history, and any parts that were ruled out rather than replaced on guesswork. For older machine tools, this can prevent unnecessary spend on boards, switches, and contactors.

Pair this note with the matching rebuild record before scope grows. Before any parcel leaves Randburg, compare the part, label and paperwork with the machine model, control type and site voltage notes. Power planning for an Adriatic machine depends on two numbers: the machine model and the supply rating at your DB board.

  • Restart checks matched to the machine
  • First alarm captured before reset
  • Written notes shared with the workshop

South African power conditions

Workshop supply in South Africa is not always steady enough for clean testing and handover. Voltage variation, unplanned outages, generator changeover, and ageing distribution boards can all affect CNC controls, lubrication cycles, and reference return. If a machine has had electrical changes, non-standard protection, or substituted parts, put that on record early.

Coastal moisture can mark terminals and connectors inside cabinets, while inland dust can clog filters and settle on drives. After a supply event, check fan operation, panel temperature, and earth continuity before longer test runs begin again. A machine that powers up is not yet proven ready for production.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Workshop record for Power Windows

A short workshop note on power windows when workshop outages interrupt testing, fitting, and machine restart checks.

Write the outage note while the sequence is still fresh. Keep it with the job card, readings, and any parts references so that purchasing and maintenance are working from the same facts.