Floor notes
Way Lube Checks
Slideways do not fail overnight, they wear one dry shift at a time. These are the checks we ask every floor to run on mills and lathes.
Why way oil gets forgotten
Way lubrication is one of those jobs everybody agrees is important and nobody owns. The reservoir is on the side of the machine, the level is hard to see, and the machine keeps cutting fine for weeks after the oil runs low. Then one day the table starts to stick, the finish goes patchy and somebody calls us for new gibs or a slideway regrind. By that stage the wear is done.
Most of the rebuild work we quote at Adriatic starts with dry ways. A five minute check at the start of each shift costs almost nothing in comparison, and it gives the operator a reason to look at the machine before pushing the start button.
Daily checks at the machine
- Reservoir level above the minimum line before the first job
- A thin, even oil film visible on exposed ways after a few traverses
- Manual pump or auto lube cycle confirmed working
- Wipers and way covers clear of packed chips
Use the right oil, not the nearest one
Way oil is not hydraulic oil and it is not the spindle oil from the other shelf. Proper slideway oil has tackifiers that make it cling to vertical surfaces and resist being washed off by coolant. Using a thin hydraulic oil because it was handy means the film disappears within a shift on a knee mill column. Check the machine manual for the grade, normally an ISO VG 68 for most manual mills and many lathes, and keep one marked can for it.
On CNC machines with automatic lube, the controller will often alarm when the tank is low, but it will not tell you when a metering valve is blocked. If one axis looks dry while the others are wet, trace that line before the next shift. Our parts desk carries common metering units and lube lines for the machines we support.
Weekly and monthly items
Once a week, run each axis through full travel slowly and look at the ways under good light. You are looking for dry patches, scoring lines or any brown staining that shows the oil is breaking down. Check the coolant too. Coolant that is too strong or full of tramp oil strips the way oil faster, so a weak or dirty mix shows up on the slideways before it shows on the parts.
Monthly, lift the way covers or wipers where you can and clean out the fines. In foundry areas and near grinding, those fines mix with oil into a paste that acts like lapping compound. Coastal shops in Durban and Cape Town should also watch for surface rust on ways that are idle over long weekends, a light coat of oil before closing helps alot.
Write it down
Put a simple card on each machine with the oil grade, the daily checks and a column for initials. It keeps the job from falling between shifts. If a machine already shows sticking or uneven wear, see our rebuilds pages and the spare logic note, then send the machine model and photos of the ways through our contact form so we can advise before it gets worse.
