Specs

Axis Encoder specs

Setup notes and briefing numbers for Axis Encoder.

Encoder dimensions to verify

Key dimensions and identification points are needed for encoder matching. If the unit is already in hand, check the specification details against the machine.

Compare the encoder in your hand with the machine requirement before ordering a replacement. Check body diameter, overall length, shaft size, mounting face, connector style, and the identification code on the label. South African workshops often send units from older mills, lathes, and machining centres where the original markings are faded or partly covered in oil.

Photos should include the label, shaft end, cable exit, and the mounting side removed from the machine. Include a tape measure or vernier in the image where possible, especially when the flange pattern is uncommon. That record helps distinguish between lookalike encoder units that fit the same axis housing but use different outputs or indexing marks.

Matching points on the unit

Encoder matching starts with the physical details, then moves to the electrical specification. Note whether the unit is solid shaft or hollow shaft, whether the coupling is clamped or keyed, and whether the machine control expects incremental feedback or another signal arrangement. A correct label number is useful, but the mounting and shaft details still need to agree with the machine.

Where label data is incomplete, compare the hub style, bolt circle, cable length, and connector position against the machine layout. On retrofits and rebuilt axis assemblies, small changes around the motor bracket can affect encoder clearance and cable routing. Worn machine-tool parts are matched from the maker's plate, so a clear shot of that plate belongs in your enquiry.

  • Body and flange checked
  • Shaft, coupling, and connector noted
  • Label code copied exactly

Workshop conditions affecting encoder checks

Units removed in Gauteng workshops often arrive with dried coolant residue, metal fines, or paint over old serial markings. Near the coast, corrosion around the connector shell and mounting screws can hide useful identification points. When the machine has stood idle after power problems, check for moisture ingress before relying on the old encoder code alone.

Dust inside the motor cover can make the fitted encoder look older than it is, while sun-faded labels can cause one digit to be misread. On machines with repeated axis faults, inspect the cable gland, earthing, and coupling for damage before assuming the encoder specification is wrong. A physical mismatch at the flange or shaft will not be solved by parameter changes at the control.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Information to send with measurements

Add the machine make, model, control type, and the axis name linked to the encoder. Include any numbers from the tag, plus your measured shaft diameter and fixing pattern if the printing cannot be read fully.

If the unit came off during a rebuild or motor repair, mention that with the job sheet reference and any replaced couplings. A short note on the fault, such as position drift, alarm at power-up, or lost reference return, helps place the specification against the machine condition.

What our Machine Tool Parts customers say

Verified Google reviews