Specs

Spares Bridge specs

Part references and working figures for Spares Bridge.

What Spares Bridge specs set out clearly

The Spares Bridge specs page gives the reference detail needed when matching hard-to-find parts to an existing machine. It is aimed at workshop staff who need a clearer route from old component to replacement item.

Record the machine model, serial reference, and the exact Spares Bridge line before ordering. Match shaft diameters, mounting centres, thread forms, and voltage details against the part removed from the machine. In South African workshops, dusty inland sites and salt air near the coast can alter wear patterns, so measured condition matters as much as the printed reference.

Include clear photos of the old component beside a rule or vernier reading. Close images of keyways, bolt spacing, broken lugs, and worn faces help separate a near match from the correct Spares Bridge item. Many older machines carry mixed assemblies, so the fitted part should be checked against the page figures, not assumed from the machine badge alone.

Dimensions that prevent mismatch

The figures should let workshop staff verify fit before a unit is stripped any further. Use the listed references to compare hole centres, overall length, bearing size, and any stated operating limits with the failed part on the bench. That reduces ordering errors where previous repairs have introduced non-standard pieces.

Check each Spares Bridge reference against the machine plate, the removed part, and the workshop record before purchase approval. Where a machine has been rebuilt more than once, note any altered brackets, adaptor plates, or rewired connections alongside the spec. Spares are confirmed against measured sizes, so share the readings from your calipers before an order is placed.

  • Mounting centres checked against the old part
  • Thread, bore, and keyway sizes recorded
  • Machine reference captured with each enquiry

Workshop conditions affecting spec checks

Gauteng dust can hide stamped numbers and speed up wear on slides, covers, and seals. In coastal areas, corrosion around fasteners and housings may alter the original dimensions slightly, especially on machines left standing. Measure the working part as fitted and note any rust build-up, packing shims, or previous machining.

Power interruptions can stop a running check halfway through, so record switchgear ratings and motor data before dismantling starts. On older shop equipment, replacement parts are often chosen by flange pattern, shaft size, and travel limits rather than by a readable maker label. The page is most useful when those physical checks are written down beside the Spares Bridge reference.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Bench notes for Spares Bridge

Use Spares Bridge for machine-tool parts that fill the gap between a breakdown, an older machine, and the next proper replacement order.

Add the verified spec line to the job sheet as soon as the part is identified. Keep the photo, measurements, and old part number together with the purchasing record so the same machine can be matched correctly on the next repair.

What our Machine Tool Parts customers say

Verified Google reviews