Specs

Training Day specs

Session notes and planning figures for Training Day.

What Training Day specs include for teams

The Training Day specs page sets out the points covered during machine use after installation. It is intended for teams dealing with the unusual faults and operator issues that appear after the first steady week.

Training Day specs records what the operators and fitters must cover once the machine is back in service. For Randburg and wider South African sites, it also notes how dust, moisture, and unstable supply can affect early machine behaviour.

Session notes should capture the machine condition before the handover starts. Include spindle sound, slide movement, guard switches, coolant flow, and any backlash or heat build-up seen during the run. Photos of the control panel, lubrication chart, and fitted parts help the next shift repeat the checks without guessing.

First-use handover points

Training Day specs sets out the checks to run with the team at the machine, not just on paper. It covers start-up order, daily inspection points, safe part changes, and the warning signs that show wear on bearings, belts, switches, or slides. The aim is to give the workshop a usable record for routine running after installation.

Use Training Day specs alongside the matching part record and service notes when the machine has had recent work done. Before ordering or fitting anything else, compare the part number, machine model, and fitted arrangement to what is on the job file. Worn machine-tool parts are matched from the maker's plate, so a clear shot of that plate belongs in your enquiry.

  • Daily checks tied to machine condition
  • Operator faults logged during first runs
  • Parts and settings noted for handover

Workshop conditions affecting settings

These specs should reflect the workshop where the machine is actually being used. A lathe near open doors in Johannesburg dust will need different cleaning intervals from a machine standing in Durban humidity, and that changes how the team monitors slides, electrics, and exposed metal. Record any prior rewiring, substituted components, or missing guards before the session starts.

Power interruptions can reset controls, interrupt warm-up, and confuse fault finding during early operation. Coastal air can push rust into chucks, fasteners, and bare guide surfaces, while inland dust can clog fans, covers, and cabinets faster than expected. Training Day should therefore include restart procedure, lubrication review, and a check of machine references against fitted parts.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Records to keep after training

Use Training Day when your team needs a practical handover on replacement parts, machine checks and workshop routines.

File the Training Day specs with the job sheet, parts list, and any machine photographs taken during handover. That gives the workshop a single reference for operator questions, replacement part ordering, and later service visits.

What our Machine Tool Parts customers say

Verified Google reviews