Specs

Way Cover specs

Setup notes and briefing numbers for Way Cover.

Way cover measurements to confirm

The Way Cover specs page sets out the measurements and fitting details needed when replacing damaged covers. It is intended for buyers checking compatibility with an existing machine and its travel requirements.

Record the machine model, axis position, and full travel before checking a replacement way cover. Measure closed length, extended length, fixing centres, and available clearance around the saddle or table. In South African shops, dust from cast iron and plasma cutting often shortens cover life, so material choice matters as much as size.

Photos should show both mounting ends, the direction of travel, and any areas where the old cover rubs or buckles. Include a ruler in the picture if the original dimensions are uncertain. That helps distinguish between telescopic steel covers, bellows, and apron styles fitted to older machines still working in Randburg and Johannesburg.

What the spec sheet must include

A useful way cover specification states travel, compressed dimension, extended dimension, mounting method, and whether swarf load is light or heavy. It should also note coolant exposure, chip type, and whether guards pass under a casting lip or over a rail. Those details affect fold spacing, slide overlap, and the hardware needed for fitting.

Before sending an enquiry, check the machine reference plate and compare it with the cover position on the machine. Add the axis name, a few measurements, and where the damaged section sits. If a previous repair changed the bracket layout, mention that so the spec can match the current setup rather than the catalogue drawing.

  • Closed and open lengths recorded
  • Mounting holes and bracket type noted
  • Coolant, swarf, and travel direction listed

Workshop conditions affecting cover choice

Fine grinding dust, hot chips, and soluble oil all place different demands on a way cover. A bellows unit may suit light contamination, while telescopic steel is usually preferred where sharp swarf lands directly on the guard. If the machine stands near a roller door or wash bay, mention moisture and windblown dirt as part of the specification.

Coastal corrosion around Durban and Cape Town can affect fasteners, painted panels, and slide surfaces under the cover. Inland sites around Gauteng often deal with dry dust that packs into folds and rails. Power cuts can interrupt test cycles, so it helps to note whether the machine was measured static or under powered movement.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Details to send with dimensions

State which axis the cover protects and whether the old unit failed by tearing, denting, or jamming. Include photos from the operator side and from above if access allows. Mention any missing wipers, broken support straps, or bent end trays.

Keep the measurements with the job card, parts list, and machine serial details for future ordering. If more than one cover is fitted, label each position clearly to avoid mixing left and right hand assemblies. That makes later replacement checks easier when the machine comes back in for service or rebuild work.

What our Machine Tool Parts customers say

Verified Google reviews