A photo protocol for machine-tool breakdowns, worn components, serial plates, and workshop layouts before quoting or strip-down.
How Photo Protocol helps on site each week
Photo Protocol sets out what to photograph when a machine breaks down or needs strip-down planning. Serial plates, worn components, overall machine views, and the workshop layout all help build a clearer picture before quoting.
Photograph the whole machine first, then move closer to the failed area, the control, and the serial plate. Include the machine type, site town, and whether it is stopped mid-job or isolated for inspection. In South African workshops, dust, coolant residue, rust marks, and poor lighting can hide useful detail unless the first image set is planned properly.
A useful photo record starts before panels are removed or parts are cleaned. Take clear images of leaks, broken teeth, worn slides, damaged covers, and any swarf build-up exactly as found. That gives a better basis for discussing strip-down work, replacement parts, and workshop access than a few rushed phone pictures after the area has been disturbed.
Machine views that matter
For this protocol, one image should show the full machine from each side, another should show the working area, and others should isolate the fault. Add close photos of handwheels, guards, lubrication points, electrical cabinets, and any labels still readable. If a part has been removed, place it on a clean surface and photograph both faces.
With any photo set, give the machine make, model if known, and where the unit is standing in the workshop. A wide shot that shows access around the base, forklift space, and nearby machines helps with handling and strip-down planning. Before anything is packed for inspection, match the part and paperwork to the serial plate photo.
- Full machine photos from each side
- Serial plate captured sharply and square
- Damaged area shown wide and close
Workshop details worth showing
The machine alone is not enough. Include the space around it, the lifting route, door widths, nearby stock, and any pit, plinth, or trench that affects removal work. If earlier repairs have changed motors, switches, guards, or mounting points, photograph those changes as part of the same set.
Images taken near the coast should show rust, staining, and storage conditions around loose parts. Inland sites often need extra attention on dust inside cabinets, fan covers, and slideways. Where power cuts or supply faults may be involved, photograph alarms, displays, and any visible power equipment linked to the machine.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
Before sending the image set
Follow this photo protocol with clear images of the machine, the job timing, and the damaged or failed parts already seen. Use an honest subject line that matches the actual issue.
Check that the photos are in focus, upright, and named in a sensible order before uploading or mailing them. Keep the set with the job record so the foreman, buyer, or fitter can refer to the same machine condition later. A short note on what happened just before the failure is often as useful as the closest photo.
